dosatron SD25AL5 Manuel D'utilisation page 47

WALL SUPPORT DOSER INSTALLATION - MONITORING
1
- Install the doser wall support with the monitoring subassembly.
2
- Remove the corrugated tail from the doser (store safely for maintenance purposes).
3
- Introduce and position the doser in the support by slightly spreading the arms of the support in order
to latch the four lugs of the main body into the corresponding support holes.
4
- Connect the monitoring module in place of the corrugated tail.
5
- Remove the protective caps (doser inlet/outlet).
5
Keep
the corrugated tail
Ensure that the water is flowing in the direction of the doser arrow.
FLEXIBLE BLADE
SWITCH MOTOR CYCLE
SENSOR CONNECTION
1
- Insert the flexible blade switch sensor unit
into the centre of the lid
2
- Lock with a quarter turn.
5
2
©
DOSATRON INTERNATIONAL S.A.S. / 11
©
DOSATRON INTERNATIONAL S.A.S. / 47
70 mm
3
4
2
1
1