JANE iRacer Mode D'emploi page 20

Les langues disponibles

D. FEATURES OF YOUR i-RACER BOOSTER

SEAT WITH BACKREST

The i-RACER safety seat has been designed using the latest ad-

vances in safety and comfort:

• The height of the shoulder belts is adjusted without the need

to remove the belt. This action is connected to the headrest

that offers better protection in the event of side impact while

simultaneously supporting the head. It has 11 different height

positions.

• The interior of the seat is covered with shock absorbing ma-

terial.

• The seat can be reclined in 4 different positions.

• It is fitted with a spacer element that provides extra protection

in the event of side impact.

E. INSTALLATION WITHOUT ISOFIX ANCHORS

• If you decide to install the i-RACER booster seat with back-

rest without the ISOFIX anchors, simply position the safety seat

on the vehicle seat, pass the seat belt through the lower belt

guides (6) and the one found on the side of the headrest (5).

These guides are marked green.

F. INSTALLATION WITH ISOFIX ANCHORS

The booster seat with backrest can be fastened with the ISOFIX

anchors, which gives it greater lateral stability.

• The ISOFIX anchors (4) are extracted by pressing the buttons

(4a).

In some vehicles, the ISOFIX anchors can be difficult to access

or they are concealed between the foam of the vehicle seat.

The safety seat comes with two guides (11) making it easier to

locate the anchor points. Insert the guides before the next step.

• Guide the anchors towards the axles in your vehicle and press

until both sides are locked into place, two green signals on the

sides of the anchors (4b) will indicate that they are anchored in

place. If one or both of the signals is red, try again.

• Press the booster seat against the backrest of the vehicle

seat.

G. ADJUSTING THE HEIGHT OF THE HEADREST

The height of the headrest can be adjusted using the handle

found on the back of the headrest (9). To release it pull the han-

dle upwards, when you release it, the headrest will lock into the

nearest position.

• Pass the shoulder section of the vehicle seat belt through the