Rollz Motion 2 Manuel D'utilisation page 77

Figuur 58: Brake adjustment via the circlip
(dark orange) and the adjusting screw, detail.
Brake adjustment at the bottom of the brake cable
If you need to tighten the brakes more than what the top adjustment will allow,
you can further adjust using the bottom brake adjustment.
a. The Rollz Motion should not be on the parking brakes while adjusting the
brakes.
b. Stay at the rear of the Rollz Motion when adjusting the brakes. Loosen the
locking ring at the bottom of the brake cable (pull the cable up to make
it easier). Turn the adjustment screw above it to shorten or extend the
brake cable (Figure 58). Turn clockwise for more braking power, and
counterclockwise for less braking power.
c. When the brake has the desired force, tighten the locking ring.
d. Do the same on the other side.
e. Check whether the braking force on the left and right side is evenly
distributed.
CAUTION
If the brakes do not function properly after adjusting them, contact your supplier
immediately and do not use the Rollz Motion.
77