Setting The Footrests (Once Only) - Rollz Motion 2 Manuel D'utilisation

e. Take the footrests out of the transport chair bag and place them at the front
of the Rollz Motion, into the footrest holders on the frame. Slide them down
from the top of the footrest holders (Figure 39). Do not apply force if the
footrests do not slide smoothly over the footrest holders. Take them out and
try again.
f. The transport chair is now ready for use (Figure 40).
Figure 39: Place the footrests.
NOTE
Do not apply force when pulling up the transport chair package does not go
smoothly. This can damage the transport chair package. Contact your supplier if
the problem continues after several attempts.
CAUTION
Before you sit down, always check that the locking bolts are correctly secured in
the guide rails. Do not sit down if one of the locking bolts is not secured. Instead,
try to place the seat again.

Setting the footrests (once only)

The Rollz Motion is supplied with two adjustable footrests. You can adjust them to
the desired height with the supplied size 5 Allen key (Figure 41).
The correct height depends on the length of the lower leg and the way the user
sits. If the footrests are set too high, there will be too much pressure on the but-
tocks. If the footrests are set too low, the pressure on the upper legs is too high.
In a correct position, the user sits with his lower legs at an angle of about 90
degrees (Figure 42).
Figure 40: Transport chair is ready to use.
65