Pulling Down The Transport Chair Package; Removing The Transport Chair Package - Rollz Motion 2 Manuel D'utilisation

Figure 48: Storing footrests mirrored.

Pulling down the transport chair package

Do you want to turn the transport chair into a rollator?
a. Remove the footrests. Slide the footrests up until released from the footrest
holders. Put them back into the bag of the Rollz transport chair package,
mirrored to each other (Figure 48).
b. Grasp the handle of the transport chair package and push the backrest
forward till halfway the frame. Then push the backrest back and down until
it gets behind the seat. Then the transport chair package is folded.
c. Loosen the adjustment handles counterclockwise and turn the handles
through the outside until they point straight forward. Set the correct height
for you and tighten the adjustment handles clockwise. See Adjusting
the height for correct posture.
d. The transport chair package stays in place when folded and the rollator can
be used to walk.

Removing the transport chair package

a. Pull up the red handle without force. This way the locking bolts are tied in,
and the transport chair package unlocked (Figure 49).
b. Hold the handle of the transport chair package and pull it up without force.
c. Then push down the red handle.
d. The package can now be stored aside, for example when transporting the
Rollz Motion in a car. The footrests remain inside.
68
Figure 49: Unlocking the transport chair
package.