Pulling Up The Rollz Transport Chair Package - Rollz Motion 2 Manuel D'utilisation

e. If the red handle is not going down without forcing it, take the transport
chair package out of the notches behind the seat and try again. Please
contact your supplier if you still have difficulties after several attempts.
NOTE
Forcing down the red handle can damage the Rollz Motion.
1
Figure 31: Transport chair package
attached.

Pulling up the Rollz transport chair package

a. Attach the transport chair package to the Rollz Motion before you go out
(Figure 31).
b. To convert the walker to a transport chair, the transport chair package
needs to be pulled up. Take the handle of the transport chair and pull
slightly up and towards the front until halfway up the frame (Figure 33).
c. Pull the backrest further up and then back (Figure 34) so that the
locking bolts click into the upper guide rails on the frame (Figure 35). If
the upper locking pins do not slide smoothly into the upper guide rails on
the frame, push the backrest forward until halfway up the frame and try
again.
d. Loosen the adjustment handles counterclockwise (Figure 36) and turn
the handles around via the outside, until they are pointing towards the back
(Figure 37). Adjust the height for the person pushing the transport chair
and turn the adjustment handles clockwise to tighten (Figure 38). See
Adjusting the height for correct posture.
3
Figure 32: Locking the transport chair package.
2
63