Fender Passport mini Mode D'emploi page 7

To activate the onboard guitar tuner, press and hold the
TAP button for 2 seconds. Strike a string on your guitar.
The "A, B, C, D, E, F, G" LEDs indicate the nearest note.
The "#" LED indicates a sharp note. Use the three LEDs
below the TAP button for fine tuning. The red LEDs indi-
cate the note is slightly flat or sharp and the green LED
indicates the note is in tune. Press the TAP button to exit
from the tuner.
Anti-Feedback
You can reduce microphone feedback at a troublesome frequency
in the VOCAL channel using the adjustable anti-feedback feature.
To select the anti-feedback frequency:
1. Press and hold the TUNER button for two seconds (this will activate
Tuner mode for the INSTRUMENT channel).
2. Rotate the EFFECTS knob to locate the anti-feedback notch fre-
quency that reduces microphone feedback the most (VOCAL chan-
nel). Rotate counter-clockwise to decrease the notch frequency and
clockwise to increase the notch frequency. Rotate fully counter-
clockwise to turn the anti-feedback feature off.
3. Press the TUNER button to exit and save the anti-feedback frequency
setting. Your custom anti-feedback setting is stored even after the
amp is turned off.
Aux/Phones Jacks
You can connect the headphone output on your MP3 player
to the AUX jack on the Passport® mini using a standard 1/8"
mini-stereo cable. Use the volume control on your player to
control the auxiliary input level. Stereo signals from your
player are output through the PHONES jack in stereo.
Plug in your headphones, ear buds, or powered speakers to
the PHONES jack to enjoy the Passport® mini in stereo. This
jack may also be used as a stereo recording output. Use the
INSTRUMENT and VOCAL channel volume controls to adjust
the output level of the PHONES jack. The amp's speaker
output is muted when the PHONES jack is used.
TYPE: PR 2501
PART NUMBERS: 0694600000 (120V, 60Hz)
0694604900 (230V, 50Hz) UK DS
0694608900 (220V, 50/60Hz) CN DS
AC/DC ADAPTER: 12VDC 800mA
POWER REQUIREMENTS:
GUITAR: >1MΩ
INPUT IMPEDANCE
POWER OUTPUT: 7W RMS into 8Ω @ 5%THD
SPEAKER: 8Ω, 6.5", Fender Special Design
HEIGHT: 9.45 in (240 mm)
DIMENSIONS
WEIGHT: 7.25 lb (3.3 kg)
• Use Fender® FUSE™ software to view the details and fully customize
presets and effects on your Passport® mini:
• Record and edit Passport® mini audio using your favorite record-
ing software. Use the INSTRUMENT and VOCAL volume controls
to adjust the USB audio output level as needed.
Battery Indicator
BATTERY
• OFF: The unit is being powered through the power adapter.
• GREEN: Battery powered, good charge.
• YELLOW: Battery powered, limited charge.
• BLINKING RED: Battery powered, replace batteries.
Firmware Updates
& Factory Restore
From time to time, Fender may make available firmware updates for your
Passport® mini amplifier to improve performance or to add new features.
To update the firmware on your amplifier you will need to connect it
through the USB port to a computer with an internet connection, run-
ning Fender® FUSE™ software. Hold down the TAP button while turning
the unit on to initiate the firmware update. You can also restore your
Passport® mini to the original factory settings if desired, using Fender®
FUSE™ .
Please download the latest version of the Fender® FUSE™ manual
from http://fuse.fender.com/support.
PRODUCT REGISTRATION — Visit:
Specifications
0694600900 (120V, 60Hz) DS 0694601900 (110V, 60Hz) TW DS
0694605900 (220V, 50Hz) ARG DS 0694606900 (230V, 50Hz) EUR DS
BATTERY POWER: Six "C" cell batteries (Battery life approximately 20 hours)
Earth grounded
AUX: >13kΩ VOCAL XLR: >2kΩ
WIDTH: 9.45 in (240 mm) DEPTH: 43.18 in (170 mm)
Product specifications are subject to change without notice.
f e n d e r . c o m
USB Port
Connect the Passport® mini USB port to your computer to take
your music to the next level:
The BATTERY indicator on your Passport® mini will show the
following states/battery conditions:
www.fender.com/product-registration
0694603900 (240V, 50Hz) AUS DS
0694607900 (100V, 50/60Hz) JPN DS
VOCAL 1/4": >2kΩ
http://fuse.fender.com
7