Fender Passport mini Mode D'emploi page 6

Getting Started
BATTERY
A C
NATURAL DREADNAUGHT
B D
PARLOR JUMBO
To set up your Passport® mini amplifier:
1. Plug in the power adapter cord -OR- install six C batteries.
2. Plug your guitar into the INSTRUMENT input jack -AND- plug your
microphone into one of the VOCAL input jacks.
3. Press the POWER switch to "ON" to turn on the amplifier.
4. Adjust the INSTRUMENT and VOCAL volume levels.
Please visit https://fuse.fender.com/passportmini
free software with installation help for your Passport® mini.
Using Presets
Use the PRESET knob to select one of 24 presets for the
INSTRUMENT channel. Presets are stored in three banks,
AMBER, GREEN and RED, in the following order:
A B
NATURAL PARLOR
A B
NATURAL PARLOR
A
B
NATURAL PARLOR
Each preset is based on one of the eight amplifier types labeled next to
each of the preset LEDs and may include effects which can be temporar-
ily changed with the EFFECTS knob.
PRESET NOTES: Please see page 22 for a complete list of preset names
with their associated amp models and effects.
Passport® mini presets can be viewed and customized using Fender®
FUSE™ software, available free of charge at http://fuse.fender.com.
6
E G
BLACKFACE BRITISH 1 TAP
F
TWEED BRITISH 2
to download
AMBER
C
DREADNAUGHT
GREEN
C
DREADNAUGHT
. . .
RED
f e n d e r . c o m
Effects/Tone
Use the EFFECTS knob to temporarily change effects for
the currently active INSTRUMENT channel preset. Each
time you turn the PRESET knob to select a different pre-
set, the effects are reset to their pre-programmed default
selection for the preset. The position of the EFFECTS knob
will NOT show the actual effect selection until the
EFFECTS knob is turned. You can program the default effects for each
preset as well as see the names and details of each effect using Fender®
FUSE™ software.
The three numbered LEDs below the TAP button indicate exactly which
effect position (1, 2, or 3) is being selected within each of the four let-
tered selection ranges (A, B, C, D). For example, effect "A-1" is shown
below:
EFFECTS SELECTIONS
A1 Small Room Reverb
A2 Large Hall Reverb
A3 Fender '65 Spring Reverb
B1 Tape Echo
B2 Tape Echo + Room Reverb
B3 Tape Echo + Chorus
Passport® mini effects can be viewed and fully customized using
Fender® FUSE™ software installed on your Mac or Windows
computer.
Use the TONE and REVERB knobs to adjust
the tone and reverb levels, respectively, for
the VOCAL channel.
Tap/Tuner
TAP
The TAP button can be used to tap in the delay time or mod-
ulation rate setting for the currently active effect. When a
delay type effect is active, the TAP button will blink
sync with the delay time setting. When a modulation type effect is
active, the TAP button will blink red
ting. (If both delay and modulation effects are simultaneously active, the
TAP button will only indicate and control the delay effect.
To use the TAP button to adjust the effect time/rate interval, simply tap
the TAP button twice in sync with the desired interval. Pressing the TAP
button only one time will set the interval to the maximum value.
Effect time/rate intervals can be adjusted with total precision
using Fender® FUSE™ software.
C1 Chorus
C2 Flanger
C3 Phaser
D1 Vintage Tremolo
D2 Vibratone
D3 Vibratone + Room Reverb
green
in sync with the modulation rate set-
in