Cebora Synstar 330 TC Manuel D'instructions page 18

5 – CONNECTOR
DB9 type (RS 232) connector to be used for updating the
welding programs.
6
7
9
3
4
6 – CONNECTOR
USB-type connector to be used for updating the welding
programs.
7 - FITTING
This is where the gas hose from the TIG torch is to be
connected.
8 – CONNECTOR
This is where the control cable of the Push Pull welding
torch is connected.
9 - SOCKET (+)
Socket where you must connect the earth cable connector
in Tig welding and the electrode clamp in MMA welding.
4 CONTROLS LOCATED ON REAR PANEL.
10 - FUSE HOLDER.
11 – GAS PIPE CONNECTION.
18
12 – SWITCH.
Starts and stops the machine
13 – MAINS CABLE
14 – PRESSURE SWITCH CONNECTOR.
Connector which receives the cable from the pressure
switch Art.1681 (optional).
1
15 – SOCKET.
Socket which receives the power cord from the cooling
unit Art.1681 (optional).
5
2
8 11
13
10
5 INSTALLATION AND START-UP
• Position the welding machine so as to allow the free
circulation of air inside and, as much as possible, prevent
metal or other dusts from penetrating.
• The machine must be installed by professional personnel.
12
14
15