Doro NeoBio 10 Mode D'emploi page 8

Out of memory
�he memory has room for up to 59 messages (including
the outgoing message) max. 15 minutes (the NeoBio
15r) or 30 minutes (the NeoBio 25r) depending on the
compression you set. When TAM FULL is shown or the
base unit flashes FF, no new messages can be recorded
until the old ones have been played back and deleted. In
that case, the telephone answer machine responds with
the outgoing message for Answer Only.
PLEASE NOTE! Remember to delete messages regularly!
Remote access
�he unit can be remotely accessed using an ordinary tone
dialling telephone.
1. Call the answer machine.
2. Press when the outgoing message is played.
*
3. Enter the PIN code, see TAM Settings. One beep
confirms correct code.
4. Select a remote access command, see below.
5. Replace the handset.
Command Function
2.......................Erase single msg during playback
4.......................Skip to previous message
5.......................Playback of messages
6.......................Skip to next message
7.......................Start the answer machine
8.......................Stop
9.......................Turn off the answer machine
Remote activation
�he answer machine can be activated via the remote
access functions.
1. Call the answer machine. It will answer after
approximately 10 rings.
2. Press when the outgoing message is played.
*
3. Enter the PIN code, see Answer machine Settings. One
beep confirms correct code.
4. Press .
7
5. Replace the handset.
English
Troubleshooting
Check that the telephone cord is undamaged and properly
plugged in. Disconnect any additional equipment,
extension cords and other phones. If the problem is
resolved, the fault is with some other equipment.
�est the equipment on a known working line (e.g. at a
neighbour's house). If the equipment works there the fault
is probably with your telephone line. Please report this to
your network operator.
No number shown when ringing
- �his function requires a Caller ID subscription from
your service provider.
Warning tone/Not possible to make calls
- �he batteries may be running low (charge the handset).
- �he hand unit may be nearly out of range. Move closer
to a base unit.
Telephone does not work
- Check that the adapter/phone cord is connected correctly.
- Check that you have selected �one Dial, see System Settings.
- Check the charge status of the handset batteries.
- Connect another functioning telephone to the network
wall socket.
The telephone continues to ring
- Some of the telephone's ringers do not follow the line
signal, which means that the signal may continue for
up to 8 seconds after answering a call.
The answer machine is not answering
- Memory may be full. Listen to/delete your messages.
- Check that the adapter/phone cord is connected correctly.
- Check that the answer machine function is turned on.
The answer machine does not respond to
remote access
- Check that you are using a tone dial telephone.
- �ry holding the buttons down longer, approximately 1
second per digit.
If the telephone still does not work, contact the place of
purchase for service. Don't forget the receipt or a copy of
the invoice.
Specific Absorption Rate (SAR)
�his device meets applicable international safety
requirements for exposure to radio waves. �his telephone
measures 0,01 W/kg (per 10g tissue). �he max. limit
according to WHO is 2W/kg (per 10g tissue).