Publicité
Les langues disponibles
Les langues disponibles
Connection
1. Connect mains adapter/phone cable to wall sockets.
2. Insert batteries (1.2V NiMH AAA) in accordance with
the markings.
3. Charge with the keypad facing outwards (24 hours the
first time).
4. Press
(left menu button).
5. Scroll
/
to HS SETTINGS.
{
}
6. Press OK (left menu button).
7. Scroll to LANGUAGE. Press OK.
8. Scroll to desired setting. Press OK.
9. Press
or
several times to exit the menu screens.
L
If the NeoBio 15r/25r base unit's display is showing -- the
answer machine is disconnected, or time/date is not set.
Battery
When the batteries are relatively new and fully-charged (10
hours) they will last for approx. 100 hours' standby time or
approx. 10 hours' call time. �hese times apply at normal
room temperature. �ull battery capacity will not be reached
�ull battery capacity will not be reached
�ull battery capacity will not be reached
until the batteries have been charged 4-5 times. It is not
possible to overcharge or damage the batteries by charging
them for "too long". It may take up to 5 minutes charging
before display wakes up, if batteries are totally empty.
Battery LED
When the batteries are running low,
warning tone will be heard when a call is in progress.
Please note that the complete battery indicator in the
display will flash as long as the handset is charging, and
when the battery is fully charged only the inner segment
will flash.
Please note!
When the battery is low or when there is too great a distance to the base
unit the telephone will be unable to connect to a line. Do not place the
base unit close to other electrical equipment, in direct sunlight or other
strong heat sources! This is to minimize the risk of any interference.
It is normal for the device to become warm during charging and this
is not dangerous. Use only original batteries. The guarantee does not
cover any damage caused by using the wrong batteries.
Paging
�he handset will ring when
pressed. �he signal will stop automatically after a while or
if the
button on the handset or the
L
base unit are pressed.
�hese times apply at normal
�hese times apply at normal
It is not
It is not
will flash and a
(on the base unit) is
J
button on the
J
English
Base unit indicators
Steady light while charging is in progress and
7
flashes when fully charged.
Only NeoBio 15r/25r:
Steady light during calls and flashes when there is
an incoming call or new message on the answer
machine.
Range
�he telephone's range depends on whether or not the radio
waves carrying the call are restricted by obstacles in their
path, and is usually between 50 and 300 metres. Coverage
can be improved by turning one's head so that the handset
is aligned with the base unit. Sound quality declines as the
limit is reached until the call is finally interrupted.
�he
symbol is shown when the phone is within range
6
and goes out/flashes when it is out of range.
Making a call
1. Enter the required number. Delete if necessary with
menu button
C
2. Press
to make the call. Press
q
Please note! (Only NeoBio 20/25r)
To switch between handset/speaker press . In speaker mode, you
cannot both speak at once – you must take it in turns to talk.
Receiving a call
1. Wait for the handset to ring.
Wait for the handset to ring.
2. Press
to answer. Press
q
Volume control
�he volume may be adjusted during a call with
Redial
Press
. Scroll among the 5 most recently dialled numbers
r
with
/
. Press
{
}
Mute button
�he microphone can be switched off/on during a call with
Temporary silent mode
When someone calls, you can press
ring signal.
.
L
to end the call.
L
.
q
to turn off the handset
C
to end the call.
/
.
{
}
.
C
Publicité
