Technical Data - Zanussi ZRB22130WA Manuel D'utilisation

Problem
The internal lamp
is off.
Unusual noises.
The compressor
does not start
immediately after
changing the tem-
perature setting.
Water on the floor
or storage shelves.
If the malfunction shows again, contact the
service centre.
These data are necessary to help you quickly
and correctly. Write the necessary data here,
refer to the rating plate.
Model description
(Mod.)
Product Number
(PNC)
Serial number
(S.N.)

Technical data

For further technical information please refer to the rating plate on the internal left
side of the appliance and in the energy label.
Dimensions
Rising time
www.zanussi.com
Probable cause
The lamp is burned.
The cabinet is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe at the
rear of the appliance, is touching
another part of the appliance or
the wall.
This is normal, no error has oc-
curred.
Water drain hole is blocked.
............................................
............................................
............................................
Height
Width
Depth
Please refer to the "Changing the light bulb"
section.
Adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the component to
the side.
The compressor starts after a period of time.
Please see the "Care and cleaning" section.
Changing the light bulb
Warning! If the LED lamp is faulty, DO
NOT CHANGE IT YOURSELF.
If the LED lamp is changed by a person
who is not qualified to do so, there is a risk
of injury and there could be serious malfunc-
tions. The LED lamp must be replaced by an
expert in order to prevent any damage. Speak
your local Service Force Centre.
Before replacing the LED lamp, switch off the
appliance and disconnect the mains plug or
switch off the fuse or the circuit breaker.
LED lamp technical data: 220–240 V.
1593 mm
554 mm
551 mm
13 hours
Remedy
9