Closing The Door; Technical Data - Zanussi ZRX307W Mode D'emploi

Problem
The compressor operates con-
tinually.
Water flows on the rear plate of
the refrigerator.
The temperature in the appli-
ance is too low.
The temperature in the appli-
ance is too high.
The temperature in the refrigera-
tor is too high.
There is too much frost.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".

Technical data

Dimension
Possible cause
The appliance has no power. There is
no voltage in the mains socket.
The temperature is not set correctly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too high.
The room temperature is too high.
During the automatic defrosting proc-
ess, frost defrosts on the rear plate.
The temperature regulator is not set
correctly.
The temperature regulator is not set
correctly.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the
same time.
There is no cold air circulation in the
appliance.
The door is not closed correctly.
The temperature regulator is not set
correctly.
Height
Width
Depth
Connect a different electrical appliance
to the mains socket.
Contact a qualified electrician.
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer than
necessary.
Let the product temperature decrease
to room temperature before storage.
Decrease the room temperature.
This is correct.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature decrease
to room temperature before storage.
Store less products at the same time.
Make sure that there is cold air circula-
tion in the appliance.
Refer to "Closing the door".
Set a higher temperature.
3. If necessary, replace the defective door gaskets. Con-
tact the Service Center.
520 mm
525 mm
587 mm
Solution
17