Replacing The Bulb; Closing The Door - Zanussi ZRG616CW Notice D'utilisation

Problem
Water flows on the rear plate of
the refrigerator.
Water flows into the refrigerator. The water outlet is clogged.
Water flows on the ground.
The temperature in the appli-
ance is too low.
The temperature in the appli-
ance is too high.
The temperature in the refrigera-
tor is too high.

Replacing the bulb

If you want to replace the bulb, do these steps:
1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing screw.
3. Unhook the moving part by pressing it as shown in
the figure.
4. Replace the bulb with one of the same power and
specifically designed for household appliances (the
maximum power is shown on the light bulb cover).
5. Fix the lamp cover in place.
6. Screw the lamp cover securing screw.
7. Reconnect the appliance.
8. Open the door and check if the light comes on.
Possible cause
The door has been opened too fre-
quently.
The product temperature is too high.
The room temperature is too high.
During the automatic defrosting proc-
ess, frost defrosts on the rear plate.
Products prevent that water flows in-
to the water collector.
The melting water outlet does not
flow in the evaporative tray above the
compressor.
The temperature regulator is not set
correctly.
The temperature regulator is not set
correctly.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the
same time.
There is no cold air circulation in the
appliance.
Do not keep the door open longer than
necessary.
Let the product temperature decrease
to room temperature before storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch
the rear plate.
Attach the melting water outlet to the
evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature decrease
to room temperature before storage.
Store less products at the same time.
Make sure that there is cold air circula-
tion in the appliance.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Con-
tact the Service Center.
Solution
17