Operation; First Use; Daily Use - Zanussi ZRX307W Mode D'emploi

Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its refrig-
erant circuit or insulation materials. The appliance shall
not be discarded together with the urban refuse and rub-

Operation

Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise to a medium
setting.
The Temperature Regulator is situated on the side of the
cabinet.
Switching off
To turn off the appliance, turn the Temperature regulator
to the "O" position.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings
to obtain the minimum coldness.
• turn the Temperature regulator toward higher set-
tings to obtain the maximum coldness.
In the ice-making compartment -2 ºC or lower tem-
perature can be reached if the Temperature regula-
tor is set according to following table:
Ambient temperature

First use

Cleaning the interior
Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm water
and some neutral soap so as to remove the typical
smell of a brand-new product, then dry thoroughly.

Daily use

Using of the ice-maker compartment
This appliance is equipped with an ice-maker compart-
ment.
14
Temperature regulator
setting
bish. The insulation foam contains flammable gases:
the appliance shall be disposed according to the appli-
cable regulations to obtain from your local authorities.
Avoid damaging the cooling unit, especially at the rear
near the heat exchanger. The materials used on this ap-
pliance marked by the symbol
+10... +16 ºC
+16... +25 ºC
+25... +32 ºC
+32... +38 ºC
However, the exact setting should be chosen keeping in
mind that the temperature inside the appliance depends
on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Important! If the ambient temperature is high or the
appliance is fully loaded, and the appliance is set to the
lowest temperatures, it may run continuously causing
frost to form on the rear wall. In this case the dial must
be set to a higher temperature to allow automatic
defrosting and therefore reduced energy consumption.
Important! Do not use detergents or abrasive powders,
as these will damage the finish.
In the ice-maker compartment can be reached -2 °C or
lower temperature depending on setting of thermostat
control.
are recyclable.
"1"
"1-2"
"2-3"
"3-4"