Periods Of Non-Operation; What To Do If - Zanussi ZRX307W Mode D'emploi

Important! Do not pull, move or damage any pipes and/
or cables inside the cabinet.
Never use detergents, abrasive powders, highly
perfumed cleaning products or wax polishes to clean
the interior as this will damage the surface and leave a
strong odour.
Clean the condenser (black grill) and the compressor at
the back of the appliance with a brush or a vacuum clean-
er. This operation will improve the performance of the
appliance and save electricity consumption.
Important! Take care of not to damage the cooling system.
Many proprietary kitchen surface cleaners contain chem-
icals that can attack/damage the plastics used in this ap-
pliance. For this reason it is recommended that the out-
er casing of this appliance is only cleaned with warm wa-
ter with a little washing-up liquid added.
After cleaning, reconnect the equipment to the mains
supply.
Defrosting of the ice-maker compartment
A certain amount of frost will always form around
the ice-maker compartment.
Important! Defrost the ice-maker compartment when
the frost layer reaches a thickness of about 3-5 mm.
To remove the frost, do these steps:
1. Turn the Temperature regulator to the "0" setting
and disconnect the mains plug from the mains socket.

What to do if...

Warning! Before troubleshooting, disconnect the
mains plug from the mains socket.
Only a qualified electrician or competent person must
do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use
(compressor, refrigerant circulation).
Problem
The appliance is noisy
The appliance does not operate. The appliance is switched off.
16
Possible cause
The appliance is not supported prop-
erly
The mains plug is not connected to
the mains socket correctly.
2. Empty the ice box.
3. Leave the door of the appliance and ice-maker com-
partment open.
4. Defrosting usually takes several hours. When finish-
ed, pour defrost water gathered out of the tray and
wipe the surfaces dry.
5. Insert the plug into the wall socket and turn the ther-
mostat control to a medium setting.
Warning! Never use sharp metal tools to scrape
off frost from the evaporator as you could damage
it. Do not use a mechanical device or any artificial
means to speed up the thawing process other than
those recommended by the manufacturer.

Periods of non-operation

When the appliance is not in use for long periods, take
the following precautions:
1. disconnect the appliance from electricity supply
2. remove all food
3. defrost and clean the appliance and all accessories
4. leave the door/doors open to prevent unpleasant
smells.
Important! If the cabinet will be kept on, ask somebody
to check it once in a while to prevent the food inside
from spoiling in case of a power failure.
Important! The appliance operates discontinuously, so
the stopping of compressor does not mean being no
current. That is why you must not touch the electrical
parts of the appliance before breaking the circuit.
Check if the appliance stands stable
(all the four feet should be on the floor)
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Solution