Periods Of Non-Operation; Troubleshooting - Zanussi ZFX31400WA Manuel D'utilisation

3. Leave the door open and remove the
freezing shelf. It is possible to scrape off
and remove smaller frost and ice with a
plastic scraper. Sweep off melting water
and it can be removed if an adequately
high tray is put in front of the appliance
and the defrost water will flow into it.
In order to speed up the defrosting
process, place a pot of warm water in the
freezer compartment. In addition, remove
pieces of ice that break away before
defrosting is complete.
4. When defrosting is completed, dry the
interior thoroughly and keep the scraper
for future use.
5. Switch on the appliance.
6. Turn the Temperature Regulator to the Full
Loaded position and leave to run for at
least 4 hours.

Troubleshooting

WARNING! Refer to Safety chapters.
What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
The compressor operates
continuously.
There is too much frost and ice.
20
7. Reload the previously removed food into
the compartments.
8. Adjust the Temperature Regulator accord-
ing to the quantity of the stored foods.

Periods of non-operation

When the appliance is not in use for long
periods, take the following precautions:
1. Disconnect the appliance from electricity
supply.
2. Remove all food.
3. Defrost (if necessary) and clean the appli-
ance and all accessories.
4. Leave the door/doors open to prevent
unpleasant smells.
Possible cause
The appliance is switched off.
The mains plug is not conected
to the mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
Temperature is set incorrectly.
Many food products to be frozen
were put in at the same time.
The room temperature is too
high.
Food products placed in the ap-
pliance were too warm.
The door is not closed correctly.
The door is not closed correctly
or the gasket is deformed/dirty.
WARNING! If the cabinet will be kept
on, ask somebody to check it once in
a while to prevent the food inside from
spoiling in case of a power failure.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Refer to "Closing the door".
www.zanussi.com