Closing The Door; Installation - Zanussi ZFX31400WA Manuel D'utilisation

Problem
The temperature in the appliance
is too low/too high
If the advice does not lead to the desired
result, call the nearest brand-mark ser-
vice.

Closing the door

Installation

WARNING! Refer to Safety chapters.
Positioning
This appliance should be installed in a dry,
well ventilated indoor climate where the ambi-
ent temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate class
SN +10ºC to +32ºC
N +16ºC to +32ºC
ST +16ºC to +38ºC
T +16ºC to +43ºC
www.zanussi.com
The water drainage plug is not
correctly positioned.
Food products are not wrapped
properly.
Temperature is set incorrectly.
The temperature regulator is not
set correctly.
The food products' temperature
is too high.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened often. Open the door only if necessary.
There is no cold air circulation in
the appliance.
Ambient temperature
Possible cause
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defectivedoor
gaskets. Contact the ServiceCenter.
Some functional problems might occur
for some types of models when operating
outside of that range. The correct opera-
tion can only be guaranteed within the
specified temperaturerange. If you have
any doubts regarding where to install the
appliance, please turn to the vendor, to
our customer service or to the nearest
Service Centre
Location
WARNING! It must be possible to
disconnect the appliance from the mains
power supply; the plug must therefore be
easily accessible after installation.
The appliance should be installed well away
from sources of heat such as radiators, boil-
ers, direct sunlight etc. Ensure that air can cir-
culate freely around the back of the cabinet.
To ensure best performance, if the appliance
is positioned below an overhanging wall unit,
the minimum distance between the top of
the cabinet and the wall unit must be at least
100 mm.
Solution
Position the water drainage plug
in the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
Set a higher/lower temperature.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Defrost the appliance.
Make sure that there is cold air
circulation in the appliance.
21