Technical Data; Installation - Zanussi ZBA22420SA Notice D'utilisation

Remove the screw
from the lamp cover.
Remove the lamp
cover (refer to the il-
lustration).
Replace the used
lamp with a new lamp
of the same power
and specifically de-
signed for household
appliances (the maxi-
mum power is shown
on the lamp cover).
Install the lamp cover.
Tighten the screw to
the lamp cover.
Connect the plug to
the mains socket.
Open the door. Make
sure that the light
comes on.

Technical data

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
www.zanussi.com
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
3. If necessary, replace the defective door
Height
Width
Depth
Positioning
Install this appliance at a location where the am-
bient temperature corresponds to the climate
class indicated on the rating plate of the appli-
ance:
stallation".
gaskets. Contact the Service Center.
1225 mm
560 mm
550 mm
12 h
230-240 V
50 Hz
19