Technical Data; Installation - Zanussi ZRB632FW Notice D'utilisation

2. If necessary, adjust the door. Refer to "Installation".

Technical data

Dimension
Height
Width
Depth
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.

Installation

Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Positioning
Install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Location
The appliance should be installed well away from sources
of heat such as radiators, boilers, direct sunlight etc. En-
sure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is
positioned below an overhanging wall unit, the minimum
distance between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the appliance
should not be positioned below overhanging wall units.
Downloaded from Fridge-Manual.com Manuals
All manuals and user guides at all-guides.com
ZRB632FW
1750 mm
595 mm
658 mm
16 h
230 V
50 Hz
3. If necessary, replace the defective door gaskets. Con-
tact the Service Center.
ZRB634FW
1850 mm
595 mm
658 mm
18 h
230 V
50 Hz
Accurate levelling is ensured by one or more adjustable
feet at the base of the cabinet.
Warning! It must be possible to disconnect the
appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
B
A
Rear spacers
You can find the two spacers in the bag with documenta-
tion.
Do these steps to install the spacers:
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
ZRB638FW
2010 mm
595 mm
658 mm
18 h
230 V
50 Hz
21