What To Do If - Zanussi ZRB22130WA Manuel D'utilisation

Masquer les pouces Voir aussi pour ZRB22130WA:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Check the water drainage hole on the
rear wall of the refrigerator compart-
ment. Clear a blocked drainage hole
with the aid of a blunt pencil and be
careful not to damage the casing with
sharp objects
• After everything is dry place appliance
back into service
Defrosting the freezer compartment
The rear wall of the refrigerator compartment
is covered in frost while the compressor is
running and thaws when the compressor is
not running. The water from the thawing frost
evaporates by itself.
However, with time, a layer of ice forms in
the freezer compartment. This should be
removed.

What to do if ...

Caution! Before troubleshooting, disconnect
the mains plug from the socket.
Only a qualified electrician or qualified person
may repair a fault that is not described in this
instruction manual.
Problem
The appliance
does not operate.
The appliance
cools too much.
The food is too
warm.
Heavy build-up of
frost, possibly also
on the door.
8
Probable cause
The appliance is not activated.
Mains plug is not plugged in or
is loose.
The fuse has blown or is faulty.
The mains socket is faulty.
Temperature is set too cold.
The temperature regulator is not
set correctly.
Door was open for an extended
period.
A large quantity of warm food
was stored in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Door seal is not air-tight (pos-
sibly after reversing the door).
Never use sharp metal tools to scrape off
frost and ice from the evaporator as this may
damage it. However, if a very thick layer of ice
forms on the interior lining, you should fully
defrost the appliance. Proceed as follows:
• Disconnect the mains plug from the
mains socket
• Remove any frozen food, wrap it in
several layers of newspaper and put it
in a cool place
• Leave the appliance door open and
place a container under the appliance
to collect the defrost water
• When defrosting is completed, dry the
interior thoroughly
• Reinsert the mains plug into the socket
to switch on the appliance
Important! Certain sounds occur whilst the
appliance is in operation (compressor and
refrigerant circulation).
Remedy Switch on the appliance.
Insert mains plug.
Check and replace the fuse, if required.
Mains supply malfunctions must be rectified by
an electrician.
Turn the temperature regulator to a warmer
setting temporarily.
Please refer to the "Control" section.
Open the door only as long as necessary.
Turn the temperature regulation to a colder
setting temporarily.
Please refer to the "Installation location" sec-
tion.
Carefully warm the leaking sections of the
door seal with a hair dryer (on a cool setting).
At the same time, shape the warmed door seal
by hand until it sits correctly.
Remedy
www.zanussi.com

Publicité

Table des Matières
loading

Table des Matières