Safety Instructions; Electrical Connection - Zanussi ZRB22130WA Manuel D'utilisation

• Do not damage the refrigerant circuit
• Do not use electrical appliances inside the food storage com-
partments of the appliance, unless they are of the type recom-
mended by the manufacturer
• Do not use water spray and steam to clean the appliance
• Clean the appliance with a moist soft cloth. Only use neutral
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects
• Do not store explosive substances such as aerosol cans with a
flammable propellant in this appliance
• If the supply cord is damaged, it must be replaced by the man-
ufacturer, its service agent or similarly qualified persons in order
to avoid a hazard

Safety instructions

Installation
Warning! Only a qualified person must
install this appliance
• Remove all the packaging
• Do not install or use a damaged appli-
ance
• Obey the installation instruction sup-
plied with the appliance
• Always be careful when you move the
appliance because it is heavy. Always
wear safety gloves
• Make sure the air can circulate around
the appliance
• Wait at least 4 hours before connecting
the appliance to the power supply. This
is to allow the oil to flow back in the
compressor
• Do not install the appliance close to
radiators or cookers, oven or hobs
• The rear of the appliance must stand
against the wall
• Do not install the appliance where there
is direct sunlight
• Do not install this appliance in areas
that are too humid or too cold, such as
the construction appendices, garages
or wine cellars
www.zanussi.com
• When you move the appliance, lift it by
the front edge to avoid scratching the
floor

Electrical connection

Warning! Risk of fire and electrical
shock.
• The appliance must be earthed
• All electrical connections should be
made by a qualified electrician
• Make sure that the electrical informa-
tion on the rating plate agrees with
the power supply. If not, contact an
electrician
• Always use a correctly installed shock-
proof socket
• Do not use multi-plug adapters and
extension cables
• Make sure not to cause damage to the
electrical components (e.g. mains plug,
mains cable, compressor). Contact the
Service or an electrician to change the
electrical components
• The mains cable must stay below the
level of the mains plug
• Connect the mains plug to the mains
socket only at the end of the installation.
Make sure that there is access to the
mains plug after the installation
3