Operation; Precautions After Operation; Catalytic Converter - Francepower KTH525C Manuel Du Propriétaire

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17

Operation

Adjust the handle to a comfortable position and maintain
good balance as recommended in this manual.
Make sure the unit is assembled properly.
WARNING
Hold the unit down firmly so you do not lose control
while cranking. If not held down properly engine could
not pull you off balance or swing the blade into an
obstruction or your body.
WARNING
Thoroughly inspect the area where the unit is to be used
and remove all stones, sticks, wire and other objects
that could cause injury if thrown at high speeds.
WARNING
Removing the cutter guard can cause damage to the
drive shaft/cable (not covered by warranty) and cause
serious injury to operator and others.
DO NOT use any accessory or attachment other than those
supplied by the manufacturer for use with this particular unit.
Use only for jobs explained in this manual.
Inspect the entire units before each use for worm, Loose or
damaged parts. DO NOT use until the unit is in proper
working order.
Pay attention to your surroundings during operation. Make
sure to maintain a distance of at least 15 m from anyone and
anything (e,g., pets and objects) nearby. This will protect you
and others from accidents and injuries caused by loose grass
and flying objects.
Do not touch the blade when the engine is running. This will
protect you and others from accidents and injuries.
WARNING
To avoid serious injury, shut down immediately if the
unit starts to shake or vibrate.
This could be a sign of danger from broken part or
missing fasteners
WARNING
To avoid serious injury after shutting down the engine,
keep fingers and feet away from the blade until all
rotation stops.
IMPORTANT
The thickness of branches which may be cut using this
trimmer is limited to up to Approximately 5mm. Never
try to cut branches thicker than this, as doing so may
result in damage to the trimmer.
10
English

Precautions After Operation

WARNING
To avoid serious injury, do not store the unit with fuel
tank, because a fuel leak could start a fire. Allow the
engine to cool before storing in any enclosure.
NOTE
Before cleaning repairing or inspecting, make certain the
cutting head has stopped.
Disconnect and secure the spark plug wire away from plug to
prevent accidental starting.

CATALYTIC CONVERTER

Catalytic Converter:
This small engine is equipped with a catalytic converter in the
exhaust system to significantly reduce exhaust emissions. The
catalytic converter converts carbon monoxide and hydrocarbons
into harmless carbon dioxide and water.
The catalytic converter requires special care.
Use only unleaded gasoline. Never use leaded gasoline.
Leaded gasoline significantly reduces the capability of the
catalytic converter.
Do not use 2-stroke oil that contains Phosphorus (P), Lead
(Pb), or Sulfur (S). These elements will reduce the life and
performance of the catalytic converter.
Before shutting the engine off, allow it to idle for a short while.
NOTE
Never stop the engine during operation while running above
idle speed.
Shut off the engine and allow it to cool before transporting or
storing the unit.
Do not put the unit on dry grass or near any flammable object
unless the engine is cold or cooled down.
Use only recommended
genuine replacement parts to
avoid creating a hazard and/or
voiding your warranty.
Store in a dry area out of the
reach of children.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kth525lEh-25skEh-25lk

Table des Matières