Dogtra RR Deluxe Mode D'emploi page 31

CHARGING THE BATTERIES
Battery Charging Procedure
Note : The unit has a partial charge when it
leaves the Dogtra facility, upon receipt of the
launcher systems, be sure to give it a full 14-hour
initial charge before the first use.
1. Attach the charging cables to both the
transmitter and receiver(s), as shown on
page 55.
2. Plug the charger into a 230-volt wall outlet.
When properly plugged in, all indicator lights
should glow red. During the charging process,
the unit will shut off. Once the battery cable is
unplugged from the unit after a full charge,
you will need to turn the unit on again before
use.
3. Full charge period for the units is 14 hours.
The lights will stay red during the charging
process. After 14 hours, unplug the charger.
Now the unit is fully charged to use.
58
CHARGING THE BATTERIES
4. After charging, cover the battery charging
receptacles with the rubber plugs on the
transmitter and receiver.
NOTE : Only use Dogtra-approved batteries,
chargers, and accessories for your Dogtra
RR Deluxe System. When a charger is not in
use, disconnect it from the power source.
59