Machine Start And Stop; Stopping The Machine - Nilfisk BR 652 Instructions D'utilisation

revised 03/2018

MACHINE START AND STOP

Starting the machine
1. Prepare the machine as shown in the previous paragraph.
2. Turn the ignition key (58) to "I" without pressing the drive pedal (4). Check if the battery green LED (62) turns on.
If the yellow or red warning light turns on, turn the ignition key (58) back to "0" and charge the batteries (see the procedure in
Maintenance chapter).
3. Drive the machine to the working place, by starting it with the hands on the steering wheel and by pressing the pedal (4).
The drive speed can be adjusted from zero to maximum speed according to the pressure on the pedal (4).
4. The forward/reverse gear is selected with the relevant lever (51) which is at the right of the steering wheel.
NOTE
The driver's seat (17) is equipped with a safety sensor, which allows the machine to be driven by pressing the pedal (4)
only when the operator is on the driver's seat.
NOTE
The machine is equipped with an anti-skid safety system (LED (72) flashing) that reduces the speed when turning and
when the machine tilts laterally, irrespectively of the pressure on the pedal.
In this case, the reduction of speed is not a malfunction but a characteristic that improves the machine stability and
safety in every condition.
5. Lower the brush deck and the squeegee by pressing the One-Touch push-button (67).
6. Press the solution flow control push-buttons (59 and 60) according to the type of cleaning to be performed.
7. Start scrubbing, by starting it with the hands on the steering wheel (1) and by pressing the pedal (4) as necessary.
NOTE
The machine is equipped with a safety system that turns on the brushes and vacuum system only when the machine is
moving.

Stopping the machine

8. Release the pedal (4).
9. It is not necessary to lock the machine during stopping or parking, because the electromagnetic brake on the wheel turns on
automatically when the drive pedal is not pressed.
10. Lift the brush deck and the squeegee by pressing the One-Touch push-button (67).
CAUTION!
In the event of an emergency, to stop all machine functions immediately, firmly press the push-button (8).
To reset the machine operation, lift the recovery tank (44) and reconnect the battery connector (9).
12/2010
INSTRUCTIONS FOR USE
9098684000 - BR 652, BR 752, BR 752C
ENGLISH
17