Nilfisk BR 652 Instructions D'utilisation page 77

revised 03/2018
Available brushes and their relevant application guides (suggestions only)
Models
General cleaning:
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Polishing:
Rubber tiles
Marble
Vinyl tiles
Cylindrical brush installation/removal (only for BR 752C)
1. Insert the ignition key (58) and turn it to "I".
WARNING!
Before pressing the One-touch push-button (67), always check that, between the deck (28) and the machine
there is no foreign material which may prevent the deck from lifting.
2. Raise the deck by pressing the One-Touch push-button (67).
3. Turn the ignition key (58) to "0" and remove it.
4. On both sides of the machine, unscrew the knobs (A, Fig. 2) and remove the side skirt assemblies (B).
5. Unscrew the knobs (C) and remove the lids (D) by pushing the knobs downwards.
6. Install the cylindrical brushes (E), or remove them to install new ones.
The cylindrical brushes must be installed on either sides.
7. Install the lids (D) and fasten them with the knobs (C).
8. Install the side skirt assemblies (B) and fasten them with the knobs (A).
WARNING!
If the machine is not perfectly assembled it can cause damages to people and properties. Always check that all
components are assembled before starting the machine. Carefully inspect the machine before using it.
F
A
C
D
B
12/2010
MIDLITE GRIT 180 MIDGRIT 240
A
E A
Figure 2
9098684000 - BR 652, BR 752, BR 752C
INSTRUCTIONS FOR USE
PROLENE
Front
ENGLISH
PROLITE UNION MIX
C
B
D
E
A
P100363
15