EHEIM incpiria 200 Mode D'emploi page 11

GB
A Unpacking / choosing location
Carefully unpack the aquarium and furniture.
The lighting equipment, cover panes and installation accessories are packaged and in the
aquarium.
A Choosing location
No sun exposure, not too much daylight. Position away from radiators, close to a mains power
socket and on a level and stable surface.
Attention should be paid to the total load on the floor.
When assembling the furniture, use a spirit level to make sure it is exactly level and ensure
that the stand is stable.
A Feet
If necessary, place furniture feet underneath to ensure a level position.
B Assembly
Remove any foreign matter such as dust, sand, etc. from the underside of the aquarium base
and the top of the furniture.
Place the aquarium on the furniture. Do not place any mats / underlays between the aquarium
and the furniture.
C Installation
C Inlet / power cable
Rear view: pass inlet hose & power cables (lighting, heating element, etc.) through dry rear
supply slot.
Tip: for easier insertion of the cable through the drilled hole, use a long, blunt item such as a
stick or ruler to help.
C Assemble inlet
Assemble installation set according to instructions enclosed.
See illustration C for recommended design
C Place cover on shaft
See illustration
Do not clean the unit – or parts of it – in the dishwater. Not dishwater
resistant!
Do not dispose of this product as normal household waste. Take it to
your local refuse collection side.
The product complies with the protection requirements of the EC Low
Voltage Directive 2006/95/EG and with 2004/108/EG.