Mounting Or Removing Of Tray; Mounting Or Removing Of Headrest; Use Of Safety Harness - Vermeiren Régina Mode D'emploi

2.8

Mounting or removing of tray

L
WARNING:
Risk of tipping over – Do not overload the tray. The maximum weight
shall be 1 kg.
Mounting the tray:
To remove the tray you can repeat the steps in opposite direction.
2.9

Mounting or removing of headrest

Mounting the headrest:
1. Take the headrest.
2. Check that the large edge is placed to the bottom.
3. Mount the headrest to the back of the shell chair by the elastic.
Remove the headrest from the back of the shell chair by the elastic.

2.10 Use of safety harness

L
WARNING:
Risk of injury – Adjust the safety harness that no strangulation of the
patient can appear and the patient can sit comfortable in the chair.
L
WARNING:
Risk of injury – Adjust the safety harness as close as possible to the
body of the patient so the patient cannot slide out the safety harness.
L
WARNING:
Risk of injury – Use the safety harness for patients that make extreme
movements. These can lead to falling out the chair.
1. Loosen screw .
2. Mount the pen of the frame of tray  to the
bushing .
3. Retighten screw  firmly by hand.
4. Mount the tray  to the frame of the tray .
5. Put the two holes  into direction of the chair.
Page 12
Regina
2013-09