Mounting Or Removing Of The Footrests; Operating The Parking Brakes - Vermeiren Express VB Mode D'emploi

2.8

Mounting or removing of the footrests

L
CAUTION:
Risk of injury – Make sure that the footrests are firmly fixated.
2.9

Operating the parking brakes

For each drive wheel your electric wheelchair has standard parking brakes.
L
WARNING:
The brakes are not used to slow down the wheelchair during
movements – Use the brake only to prevent the wheelchair from unintended
movements.
L
WARNING:
Good operation of the brakes is influenced by wear and
contamination of the tires (water, oil, mud, ...) – Check the condition of the tires
before each use.
L
WARNING:
The brakes are adjustable and can wear – Check the operation of the
brakes before each use.
The mounting of the footrests is done as follows:
1. Hold the footrest sideways at the outside of the
wheelchair frame and mount the tube hood
frame.
2. Swing the footrest inwards till it clicks in position.
3. Swing the foot plate downwards.
4. Check that the footrest is well fixated.
To take off the footrests:

1. Pull handle .
2. Swing the footrest to the outside of the wheelchair till it
comes loose from the guidance.
3. Pull the footrest from tube hood
To apply the brakes:
Push the brake levers  forward till you feel a
1.
distinctive click.
L
CAUTION:
Risk of unintended movement –
Make sure the wheelchair is on a flat
horizontal surface before releasing the
brakes. Never release both brakes
simultaneously.
To release the brakes:
Release one brake by pulling the lever 
1.
backwards.
2. Release the second brake by pulling the lever
backwards.
Page 13
Express VB
2016-08

into the

.