Mounting Or Removing Of The Footrests; Operating The Brakes - Vermeiren V300 Mode D'emploi

EN
2.4

Mounting or removing of the footrests

2.5

Operating the brakes

L
WARNING:
movements – Use the brake only to prevent the wheelchair from unintended
movements.
L
WARNING:
contamination of the tires (water, oil, mud, ...) – Check the condition of the tires
before each use.
L
WARNING:
brakes before each use.
To apply the brakes:
1. Push the brake handles forward till you feel a distinctive click.
L
CAUTION:
horizontal surface before releasing the brakes. Never release both brakes
simultaneously.
To release the brakes:
1. Release one brake by pulling the handle backwards.
2. Hold the hand-rim of the release wheel with your hand.
3. Release the second brake by pulling the handle backwards.
The mounting of the footrests is done as follows:
1. Hold the footrest sideways at the outside of the
wheelchairs frame and mount the tube hood
the frame.
2. Swing the footrest inwards till it clicks in position.
3. Swing the foot plate downwards.
To take off the footrests:
1. Pull handle
2. Swing the footrest to the outside of the wheelchair till
it comes loose from the guidance.
3. Pull the footrest from tube hood
The brakes aren't used to slow down the wheelchair during
Good operation of the brakes is influenced by wear and
The brakes are adjustable and can wear – Check the operation of the
Risk of unintended movement – Make sure the wheelchair is on a flat

.
Page 8
V300
2010-11

into

.