Publicité
Application
Tempering the media in the bath container.
Use with the RV 10 and RV 8 series of rotary evaporators.
.
Do not use the device to prepare food!!
Operating elements, see fi g. 11
D
At every start the used software version and the set operating
The heating bath temperature is held constant by the control
circuit and is additionally monitored by the safety circuit.
In the event of an error in the control circuit, the heating bath
is switched off permanently by the safety circuit.
An error in the control or safety circuit is shown on the display,
The 'Heating' function can no longer be started.
When switching off the heating function and the medium
temperature is higher than 50° C, on the LC display is shown
Commissoning
The unit is ready for service when
the mains plug has been plugged
in.
Correct use
Range of use
- Laboratories
- Pharmacies
The safety of the user cannot be guaranteed if the appliance is
operated with accessories that are not supplied or recommended
by the manufacturer or if the appliance is operated improperly
of the tempering medium due to the used evaporator piston size
rator piston).
Set target temperature
shes on the display, see also "Setting the safety temperature".
The display then switches from "SafeTemp" to "Temp" and
the SET function is activated.
C
Set the desired heating bath target temperature by turning
The SET function fl ashes every few seconds.
Fig. 11
The SET function stops fl ashing.
Operating modes
Operating mode A
The heating function is switched off.
The target value is set to 20 °C.
The target value setting can be adjusted.
The controller tempering medium is set to water.
The heating function must be restarted following a power
failure.
The following settings are possible/adjustable:
- the target value,
- the safety circuit,
- the controller tempering medium.
When the device is switched on at the mains switch, A ap-
Factory setting: Mode A
- Schools
- Universities
12
Publicité
Chapitres
