Operating Instructions; Safety Instructions - IKA HB 10 Mode D'emploi

For your protection
Read the operating instructions in full be-
fore starting up and follow the safety in-
structions.
accessed by everyone.
and safety and accident prevention regulations.
the hazard category of the medium to be processed. Otherwi-
se there is a risk of splashing liquids.
carry and hold it.
damage. Do not use damaged components.
Caution! Only process and heat up media that has a fl ash
point higher than the adjusted safe temperature limit of the
heating bath that has been set.
The safe temperature limit of the heating bath must always
used.
Danger of being burnt! When in operation the
upper corner of the bath can heat up to 180 °C.
be switched off and disconnected from the power supply at
the plug.
Unpacking
- Please unpack the device carefully
- In the case of any damage a fact report must be set imme-

Safety instructions

Caution! The preferred tempering medium in the heating bath
There is a risk of burning when using tempering media with
lower fl ashpoints!
is recommended.
oil as the tempering medium.
tra energy produced through processing. This also applies to
any extra energy produced in other ways, e.g. through light
irradiation.
not operate the appliance in explosive atmospheres, with
hazardous substances or under water.
bed in the "Accessories" chapter.
a cut in the power supply.
work if the device power switch is off or the plug is pulled out.
For protection of the equipment
mains voltage.
Unpacking
Heating bath IKA
- Heating bath
- Mains cable

- Operating instructions

HB 10
®
11