Assembly Preparation; Assembly Instructions; Mounting The Legs To Lower Cabinet Assembly - Pit Boss PBV2G1 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Parts are located throughout the shipping carton, including inside the gas smoker. Inspect the unit,

parts, and hardware blister pack after removing from the protective shipping carton. Before assembly

of product, review all parts and reference the parts list. If any part is missing or damaged, do not

attempt to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss

Customer Service for parts.

IMPORTANT: To ease installation, must using two people is helpful when assembling this unit.

Tools required for assembly: screwdriver and wrench. Tools is not included.

IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not

tighten screws completely until all screws for that step have been installed, or unless otherwise

mentioned.

1. MOUNTING THE LEGS TO LOWER

SMOKER CABINET ASSEMBLY

Parts Required:

1 x Lower Smoker Cabinet with Control Panel

Assembly (#14)

1 x Right Front Leg (#22)

1 x Left Front Leg (#21)

1 x Right Rear Leg with Wheel Assembly (#18)

1 x Left Rear Leg with Wheel Assembly (#20)

12 x 1/4-20*1/2"Screw (#B)

Installation:

• Place a piece of cardboard on the floor to

prevent scratching the unit. Remove the Door

Assembly (#10) and set aside. Lay the Lower

Smoker Cabinet with Control Panel Assembly on

upside-down on the cardboard as Fig.1 shown.

• Mount Right Front Leg (#22),Left Front Leg

(#21), Right Rear Leg with Wheel Assembly

(#18) and Left Rear Leg with Wheel Assembly

(#20) to the Lower Smoker Cabinet with Control

Panel Assembly (#14) using 12 x1/4-20*1/2"

Screws (#B)as Fig.1 & Fig.1.1 shown, tighten

inside screws only, but do not tighten all outside

screws yet as Fig.1 shown.