VOLTCRAFT GT-6000 Notice D'emploi page 45

1 Test socket for connecting the device to be tested
2 Button for testing devices of protection class 1 (devices with protective conductor and touchable conductive parts
connected to the protective conductor)
3 Button for testing devices of protection class 2 (protective insulated devices without protective conductor and with
touchable conductive parts) and for testing devices of protection class 3 (safety low voltage)
4 Button for testing the protective conductor current (differential measurement) or the contact current (direct meas-
urement) under operating conditions (the test object is supplied with mains voltage)
5 Button for switching the test voltage (250 V DC or 500 V DC) for measuring the insulation resistance
6 Button for testing 30 mA residual current circuit breakers (RCCB/RCD)
7 Button for testing three-phase devices under operating conditions (using optional measurement adapter)
8 Display, shows test progress and the individual results
9 4 mm test socket, for connecting the test lead with alligator clip
10 IEC low-power connector (IEC 60320 C14) for connecting the IEC low-power cable (IEC 60320 C13) or for con-
necting the measurement signal cable of the optional measurement adapter (16 A CEE adapter, three-phase,
active)
11 IEC low-power connector (IEC 60320 C20) for mains connection. For connecting the mains cable with low-power
mains connector IEC 60320 C19. For supplying mains voltage (230 V, 50 Hz) or for voltage measurement at
external earthed sockets
12 USB-C interface for connecting the USB connection cable
13 Button for saving the displayed measured values (display values)
14 Button for retrieving saved measured values (display values)
15 On/Off button
45