Secure The Bath With Airjets To The Subfloor - Remote - Kohler K-1110 Mode D'emploi

9. Secure the Bath with Airjets to the Subfloor - Remote
CAUTION: Risk of product damage. Do not lift the bath by the piping or blower motor, or use the
piping or blower motor for structural support of the bath.
CAUTION: Risk of product damage. Do not support the bath by the rim.
Choose the installation option that best applies to your particular installation. Follow the
appropriate instructions.
If the subfloor is not level, shim the bath support blocks as necessary.
Option for Using a Cement or Mortar Bed
NOTE: Do not use gypsum cement or drywall compound for this application, as they will not provide an
acceptable, durable bond.
Spread a 2" (5.1 cm) thick layer of cement or mortar on the subfloor where the bath will be set. This
will help secure, level, and support the unit. Clear all the material away from the four support block
locations.
Position a piece of plastic drop cloth material on top of the cement or mortar bed.
With help, carefully lift the bath into place.
Ensure the blower motor control and support blocks are not resting in the bed material.
Insert the drain tailpiece into the trap. Ensure the bath is level and resting on all support blocks.
Remove the protective tape from the rim.
Apply a continuous bead of high-quality silicone sealant around the entire rim of the bath. Allow
the sealant to cure as per the manufacturer's instructions.
Option for Using Construction Adhesive
Apply a generous amount of high-quality construction adhesive to the bottom of the support blocks.
With help, carefully lift the bath into position.
Insert the drain tailpiece into the trap. Ensure the bath is level and resting on all support blocks.
Remove the protective tape from the rim.
Apply a continuous bead of high-quality silicone sealant around the entire rim of the bath. Allow
the sealant to cure as per the manufacturer's instructions.
Option for Using Silicone Sealant
With help, carefully lift the bath into position.
Insert the drain tailpiece into the trap. Ensure the bath is level and resting on all support blocks.
1035472-2-E
Spread a 2" (5.1 cm)
layer of cement or
mortar bed material.
Clear spaces
for support
blocks.
14
Apply a bead of
silicone sealant
around the entire
rim.
OR
Apply construction
adhesive to the
support blocks.
Kohler Co.