Maintenance - Wessamat W20 W Mode D'emploi

CAUTION: Remove and discard the first two or three ice cube batches from the storage container, since
they may contain cleaner residue and may therefore not be suitable for consumption.
NOTE: The procedure described here does not constitute intense cleaning. Intense cleaning has to be
carried out by a specialist, since the machine has to be removed. If you have any further questions
regarding cleaning, please contact your specialist dealer or the WESSAMAT service department.

7.2 Maintenance

Regularly check the water supply tube and water drain tube for leaks and adequate gradient.
For water-cooled machines, the cooling water controller should be checked regularly for proper function,
because failure of the cooling water controller to close or close fully will lead to increased water consumption
and therefore higher operating costs. The condensation temperature should be 30°C. With the machine
switched off, no water should emerge from the cooling water drain tube. Built-in machines may have to be
removed for this purpose.
During reinstallation, prevent bending or kinking of the drain tube, so that the water can drain freely!
Other maintenance work should only be carried out by authorised WESSAMAT service technician or
service staff from authorised specialised dealers!
The frequency of maintenance depends on the place of installation and the water quality (e.g. water hardness,
E
contaminants etc.). Maintenance schedules therefore have to be determined individually and can either be
N
agreed jointly or recommended by your specialist dealer.
G
L
I
S
C
H
E
N
G
L
I
S
H
A
N
G
L
A
I
S
28