Power Cable; Water Drain - RIB MAGIC Manuel D'instructions

FIG. 7 - TRANSMISSION LEVER OFFSET UP TO 45 mm FROM THE GATE HINGES
A - DO NOT USE
B - Weld to the gate with the pivot, as shown in Fig. 7
FIG. 8 - TRANSMISSION LEVER GATE LOAD-BEARING SUPPORT

POWER CABLE

A - Use only when the gate weighs excessively on the motor.
B - Weld with the pivot inserted half-way into the transmission lever slot, as shown in Fig. 8
WELD
7
23
WELD

WATER DRAIN

G
B
8