Complete The Finished Wall/Deck; Complete The Concrete Installation; Clean-Up After Installation - Kohler K-723 Guide D'installation

Stud Framing or
Concrete Wall
Water-Resistant
Wall Material
Bath

14. Complete the Finished Wall/Deck

If you have not already done so, carefully remove the protective tape from the bath rim.
Cover the framing with water-resistant wall/deck material. Seal the joints between the bath rim
edge and the water-resistant wall/deck with silicone sealant.
Tape and mud the water-resistant wall/deck material. Install the finished wall/deck to the
water-resistant wall/deck material. Seal the joints between the bath rim and the finished wall/deck
material with silicone sealant.
Install the faucet trim according to the instructions packed with the trim.

15. Complete the Concrete Installation

If you have not already done so, carefully remove the protective tape from the bath rim.
Apply mortar and tile to any wall, deck, and surround material as needed.
Apply a bead of sealant where the tile meets the bath surface.
Install the faucet trim according to the instructions packed with the trim.

16. Clean-Up After Installation

Clean the area around the blower motor of all dust and debris.
Use warm water and a liquid detergent to clean the surface of the bath. Do not use abrasive
cleansers, as they may scratch and dull the bath surface. Do not use powdered cleaners unless the
cleaner is fully dissolved in water. Solid substances could block the airjets. Do not use bleach or
ammonia cleaning solutions. Chemically active cleaning solutions can damage the bath surface.
Refer to the Homeowners Guide for normal cleaning recommendations.
Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners
containing petroleum distillates to remain in contact with any bath surfaces for long periods of
time. Remove plaster by carefully scraping with a wood edge. Do not use metal scrapers, wire
brushes, or other metal tools. Use a powder-type detergent on a damp cloth to provide mild
abrasive action to any residual plaster.
Kohler Co.
All manuals and user guides at all-guides.com
Finished Wall
Install the finished wall
material 1/16" (2 mm)
above the enameled
surface.
19
Silicone
Sealant
1143444-2-A