V-ZUG Cooler V200 Notice D'installation page 61

Fig. 56
u Pull out the fitting aids, turn them round and put them in
the adjacent opening.
Fig. 57
u Clip the cover on the crosspiece on the handle side.
Fig. 58
u Attach the custom panel and loosely screw the lock nuts
onto the adjusting bolts.
Fig. 59
u Align the custom panel in the X and Y direction using the
adjusting bolts.
* Depending on model and options
Installing the appliance in the recess
Fig. 60
u Screw on the lock nuts and check the height.
Fig. 61
u Check the gap between the door and the surrounding
custom door panels. For unit fronts thicker than 19 mm,
take account of the dimensions and advice in the chapter
Unit fronts.
Fig. 62
u Open the cover to fit the mounting bracket on the custom
door panel. Align the front edge of the mounting bracket
parallel with the custom door panel edge and screw the
bracket down tightly. Fold up the cover.
Fig. 63
61