Mounting The Front Of The Cabinet - V-ZUG Cooler V200 Notice D'installation

Installing the appliance in the recess
Fig. 49
u The sealing strip is magnetic. Position the sealing strip
below the top cover and press it in. If necessary, shorten
the sealing strip to the required length with a sharp pair
of scissors.
Fig. 50
The supplied height adjuster is used to optimise noise.
Both parts of the height adjuster are included in the
accessory kit.
u To stabilise the appliance at the back underneath: Fit the
handle onto the rail of the height adjuster and push the
rail into the appliance base. Remove the handle and do
the same with the second rail.

14.4 Mounting the front of the cabinet

Fig. 51
u Close the door and check the preset of 8 mm from
the upper edge of the appliance door to the crosspiece
support
60
Fig. 52
u Push the fitting aids to the height of the custom door
panel. The bottom of the fitting aid must be level with the
top of the custom door panel to be mounted.
Fig. 53
u Loosen the counter nut and remove the crosspiece.
Fig. 54
u Hang the crosspiece on the inside of the custom door
panel and make sure it is central.
Fig. 55
u Fix the crosspiece using at least 6 screws for panel doors
and at least 4 screws for panel doors.
* Depending on model and options