Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Setting up the appliance
u Remove all protective films from the appliance. Do not
use sharp or pointed objects for this.
u Take the power cable from the rear of the appliance.
Remove the cable brackets when you do this, otherwise
there will be noise caused by vibrations!
9 Setting up the appliance
CAUTION
Risk of injury!
u The appliance must be transported to its place of instal‐
lation by two people.
WARNING
Unstable appliance!
Risk of injury and damage. The appliance can topple over.
u Attach the appliance according to the operating instruc‐
tions.
WARNING
Fire hazard and danger of damage!
u Do not place appliances emitting heat e.g. microwaves,
toasters etc. on the appliance!
If possible, have the appliance installed in the kitchen unit
by a professional.
Do not install the appliance on your own.
9.1 After installation
u Remove all transport safety components.
u Pull off the transport lock
on the appliance door.
u Clean the appliance (see User Guide, Cleaning the appli‐
ance).
10 Disposing of packaging
WARNING
Danger of suffocation due to packing material and plastic
film!
u Do not allow children to play with packing material.
The packaging is made of recyclable materials:
-
corrugated board/cardboard
expanded polystyrene parts
-
52
polythene bags and sheets
-
-
polypropylene straps
nailed wooden frame with polyethylene panel*
-
u Take the packaging material to an official collecting
point.
11 What the symbols mean
Fig. 4
*
Risk of injury here! Follow the safety
notes!
These instructions apply to a range
of models. Follow this step only if it
applies to your appliance.
To install, please follow the detailed
description in the Guide.
This section applies either to a
single-door appliance or a double-
door appliance.
Choose one of the options: Appli‐
ance with right-hinged door or appli‐
ance with left-hinged door.
Installation step required if your
model has IceMaker and/or Infinity‐
Spring.
Just loosen the screws or tighten
them slightly.
Tighten the screws.
Check to see if the next step applies
for your model.
Check the correct assembly/seat of
the components used.
Measure the specified measurement
and adjust if necessary.
Tool for assembly: Metre rule
Tool for assembly: Cordless screw‐
driver and attachments
* Depending on model and options
Publicité
Table des Matières
