Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4 Recess dimensions
4.1 Internal dimensions
Fig. 3
F (mm)
G
(mm)
Cooler
874–
V200 88G
890
Cooler
1216–
V600 122
1236
KG
Freezer
560–
V4000
570
178N
Cooler
1772–
V4000
1788
178K
Cooler
V4000
178KG
The specified energy consumption was determined with a
kitchen unit depth of 560 mm. The appliance will work prop‐
erly at a kitchen unit depth of 550 mm, but with a slightly
higher energy consumption.
u Check the wall thickness of adjacent cabinets: It must be
at least 16 mm.
u Only fit the appliance into stable, solid kitchen units.
Secure the unit against tipping.
u Align the cabinets with a spirit level and a try square. If
necessary, level them by putting something underneath
them.
u Make sure floor and the side panels of the cabinet are at
right angles to each other.
* Depending on model and options
H (mm)
J
L (mm)
(mm)
min.
550,
min.
recom‐
max. 19
500
mended
560
Recess dimensions
5 Ventilation requirements
NOTICE
Covered vents!
Damage. Appliance can overheat, which can reduce the
service life of various parts of the appliance and lead to
operational impairments.
u Always make sure there is good ventilation.
u Always keep vents or ventilation grids in the appliance
housing and in the kitchen furniture (fully integrated
appliance) unobstructed.
u Always keep the fan air vents unobstructed.
Always follow the required ventilation gaps:
-
The depth of the ventilation shaft at the back of the
cabinet must be at least 38 mm.
-
At least 200 cm
2
is required for the ventilation cross-
sections below the unit at its base and above the unit in
the surrounding cabinet.
As a rule, the larger the ventilation cross-section, the
-
more efficiently the appliance will run.
Sufficient ventilation is required for the operation of the
appliance. The provided ventilation grids ensure an effective
ventilation gap on the appliance of 200 cm
the ventilation grids with a panel this must have the same
size or larger ventilation gap than the grid provided by the
manufacturer.
6 Custom panel weights
6.1 Weight
NOTICE
An excessively heavy custom panel can potentially cause
damage!
If the custom panel is too heavy, damage to the hinges
cannot be ruled out, which may compromise the function‐
ality of the unit.
u Before fitting the custom panel, ensure the custom panel
does not exceed the permissible weight.
Recess heights
Appliance type Maximum
(cm)
88
Cooler V200
122
Cooler V600
178
Freezer V4000
Cooler V4000
Single-door fridges and freezers
7 Transporting the device
u Transport the appliance in its packaging.
u Transport the appliance upright.
u Use two people to transport the appliance.
8 Unpacking the appliance
Before you connect the appliance, report any damage imme‐
diately to the delivery company.
u Check the appliance and the packaging for damage
during transport. Contact the supplier immediately if you
suspect any level of damage.
u Remove all materials from the back or the side walls
of the appliance that may prevent proper installation or
ventilation.
2
. If you replace
weight
of
custom panel (kg)
16
19
26
51
Publicité
Table des Matières
