cecotec Conga 990 Vital Manuel D'instructions page 16

ENGLISH
Fig. 29.
Activate the All in One function from the remote control for the robot to vacuum, scrub and
sweep at the same time thanks to its Wet & dry tank.
Note: If you want to sweep the floor, skip the water-filling step.
To ensure perfect scrubbing from the start, it is suggested to dampen the mop cloth evenly
with water before use.
Spot mode
Fig. 30.
The robot will carry out an intense cleaning of a specific area when this mode is activated. It
will start cleaning at a specific point and will move outwards in a spiral motion (1 metre). Then,
it will return to the starting point in a spiral motion again. Finally, it will activate Auto cleaning
mode and will clean until it runs out of battery.
Before operating the robot with spot cleaning mode, place it on the spot to be cleaned.
Press the spot cleaning button on the remote control.
Edge mode
Fig. 31.
When this mode is selected, the robot will clean along walls and around furniture (table or
chair legs, for example). Press the edge cleaning button on the remote control.
Room mode
Fig. 32.
The robot will carry out a 30-minute cleaning cycle when this mode is activated. Press the
room cleaning button on the remote control.
To ensure an efficient cleaning of the room, close the door.
Suction power level function
Fig. 33.
Press the suction power level button on the remote control in order to control the robot's
suction power during the cleaning process. There are 3 power levels: Turbo, Normal and Eco.
Scrubbing intensity levels function
Press the water intensity button on the remote control to adjust the water intensity during the
scrubbing process. There are 3 water intensity levels: High, Medium and Low.
Cleaning scheduling
This robot includes scheduling settings in order for you to customize the cleaning cycles. The
robot can only be scheduled through the remote control or through the App (only models with
App).
CONGA 990 VITAL
30
Note: Make sure the remote control is close to the robot when setting the clock or scheduling
cleaning cycles.
Setting the remote control's time
Fig. 34.
Press the time button on the remote control. Digits will start blinking.
Fig. 35.
Select the current day of the week by pressing the up and down arrows.
Use the left and right arrows to set minutes and hours. Use the up and down arrows to change
the digit while it blinks.
Fig. 36.
Finally, press the power button or the time button. The robot will beep when the time settings
have been confirmed.
Setting cleaning schedule
For a better and more comfortable cleaning, the robot includes a schedule function to set daily
schedules through the remote control. In accordance with the configuration, the robot will
automatically start cleaning the selected days at the desired time.
The time options on the remote control are: 12:00 a. m.–11:59 p.m. and 12:00 p.m.–11:59 p.m.
Before setting the time and the robot configuration, make sure the robot's power switch is ON
and that the power button on the robot is on.
Configuration with the remote control
Fig. 37.
Press the schedule button on the remote control. Digits will start blinking.
Fig. 38.
Use the up and down arrows to select the day. Once you have selected it, use the left and
right arrows to select minutes and hours. Use direction buttons when digits are blinking to
configure the desired minutes and hours. Press the power button to save the settings. Enter
the desired days and follow the same steps to schedule them.
Fig. 39.
Finally, press the power button to quit the scheduling mode. The robot will beep once indicating
the scheduled cleaning settings have been confirmed.
The user may schedule as many days per week as desired. The home screen will display the
scheduling button when the robot is scheduled.
Cancelling the scheduled cleaning
Fig. 40.
Press the schedule button on the remote control, select the day you wish to delete and change
the set time to 00:00 am., this is the time to be set to cancel the cleaning program.
ENGLISH
CONGA 990 VITAL
31