Cameo FLAT PRO SPOTIX Manuel D'utilisation page 9

CONTROLLER, CONTROLS AND INDICATORS:
POWER IN
1
Neutrik powerCON power input socket. Operating voltage 110 - 240 V AC / 50 - 60 Hz. Connection via the
supplied powerCON power cord.
POWER OUT
2
Neutrik powerCON power output socket. Used to supply power to additional CAMEO projectors. Make sure
that the total current consumption in amperes (A) of all connected devices does not exceed the specified
value on the device.
FUSE HOLDER
3
IMPORTANT INFORMATION: Replace the fuse only with a fuse of the same type and rating. If the fuse blows
repeatedly, please contact an authorised Service Centre.
LIT LC DISPLAY
4
Displays the operating mode and other system settings. The illumination of the LC display switches off
automatically after approx. 70 seconds of inactivity. Pressing any one of the 4 control buttons will turn the
illumination of the LC display on again.
5 CONTROL BUTTONS
MODE: Selection of the standalone functions, DMX modes, and DMX address.
ENTER: Makes it possible to change a value and confirm changes.
UP and DOWN buttons: Press the UP and DOWN buttons, for example, to adjust the microphone sensitivity,
the stroboscope speed or DMX address.
DMX IN
6
3-pin male XLR socket for connection of a DMX controller (e.g. DMX Mixer).
DMX OUT
7
3-pin XLR socket for looping through the DMX control signal.
DMX IN
8
5-pin male XLR socket for connection of a DMX controller (e.g. DMX Mixer).
DMX OUT
9
5-pin XLR socket for looping through the DMX control signal.
9