Using Your Remote Control - Kohler K-1188 Guide Du Propriétaire

Masquer les pouces Voir aussi pour K-1188:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Heater
Power
On/Off
On/Off

Using Your Remote Control

NOTE: There are two types of remote controls available: a basic unit and a unit with controls for
chromatherapy and effervescence. Determine which unit you have and follow the corresponding
directions.
NOTE: Your remote requires two AAA batteries. To install or replace them, simply unscrew the base of the
remote.
NOTE: Your overflowing bath is equipped with a waterproof remote.
To turn the pump on and off, press the power button. The heater normally turns on with the pump.
Press the heater icon to turn the heater off. The indicator ring will appear light green or yellow
green in color. The heater will not operate if the pump is off. Press the heater icon again to turn the
heater on. The indicator ring will appear dark green when the heater is on.
Press the effervescence icon to turn the pump off. Press it again to turn the pump back on.
To cycle the chromatherapy lights through the spectrum of colors, press the chromatherapy cycle
icon.
To lock an individual chromatherapy color in, press the chromatherapy specific color icon.
Programming the Remote
IMPORTANT! Programming the remote control is required. Your whirlpool will not respond to any
remote control until you program the remote. If you replace the remote control or replace the pump
control, it will be necessary to program the remote control.
NOTE: To program the remote you must turn off the breaker controlling the power to the overflowing
bath. Perform the following steps within three minutes after restoring power.
When power to the overflowing bath is turned on, the pump control switch will flash for three
minutes. It flashes between yellow and green.
Press the pump control switch to enter the learn remote function. The pump control switch will
flash green.
Press any button on the remote. The overflowing bath will only respond to this remote.
NOTE: If you do not press any of the buttons on the remote within three minutes, the overflowing bath
will not respond to the remote control.
1019731-5-C
All manuals and user guides at all-guides.com
Chromatherapy
Specific Color
Selection
6
Power
On/Off
Heater
Effervescence
On/Off
Mode
Chromatherapy
Cycle
Kohler Co.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

K-1189

Table des Matières