Using Your Remote Control; Programming The Remote - Kohler K-1188 Guide D'utilisation

Heater
On/Off

Using Your Remote Control

IMPORTANT! Your remote is pre-programmed to work with any overflowing bath. If you have multiple
units or your remote does not work, you may need to reprogram it.
NOTE: There are two types of remote available, a basic unit and a unit with controls for chromatherapy
and effervescence. Determine which unit you have and follow the corresponding directions.
NOTE: Your remote requires two AAA batteries. To install or replace them simply unscrew the base of the
remote.
Your overflowing bath is equipped with a waterproof remote.
To turn the pump on and off, press the power button. The heater normally turns on with the pump.
Press the heater icon to turn the heater off. The indicator ring will appear light green or yellow green in
color. The heater will not operate if the pump is off. Press the heater icon again to turn the heater on. The
indicator ring will appear dark green when the heater is on.
Press the effervescence icon to turn the pump off. Press it again to turn the pump back on.
To cycle the chromatherapy lights through the spectrum of colors, press the chromatherapy cycle icon.
To lock an individual chromatherapy color in, press the chromatherapy specific color icon.

Programming the Remote

IMPORTANT! You will only need to program your remote if you have multiple overflowing baths
installed or you are instructed reprogram it by the troubleshooting guide. The remote will be ready to use
immediately in most instances.
NOTE: If you are programming the remote when first installing the overflowing bath, you must perform
these steps in the first three minutes of operation.
NOTE: If you are programming the remote after the overflowing bath has been in operation, you must
turn off the breaker controlling power to the overflowing bath. The following steps should be performed
within three minutes after power to the overflowing bath is restored.
When power to the overflowing bath is turned on or restored, the pump control switch will light up for
three minutes. It will display yellow, then flashing green.
If the switch is pressed during this time it will enter the learn remote function. The green led will be
flashing.
If no icon is pressed, all overflowing bath remotes will work with this unit. If any remote button is pressed
your overflowing bath will only function with this individual remote.
1019731-5-B
Power
On/Off
Heater
On/Off
Chromatherapy
Specific Color
Selection
6
Power
On/Off
Effervescence
Mode
Chromatherapy
Cycle
Kohler Co.