Kohler Sterling 600B Serie Guide D'installation page 9

M
6. Install the Top Track
Measure the distance from wall to wall at the top of the wall jambs.
Mark the top track at the determined dimension.
NOTE: For best results use a 32-teeth per inch hacksaw and miter box.
Cut the top track on the inside edge of the mark [approximately 1/32" (1 mm) from the mark] to
allow space for the top track to slide into place easily.
Carefully file the rough edges smooth where the top track was cut, taking care to avoid damaging
finished surfaces.
Position the top track over the wall jambs and gently push down.
7. Install the Panel Guide
Position the panel guide on the bottom track, perfectly centered between the wall jambs, with the
top edge of the guide positioned in the groove on the front of the bottom track.
Using the hole in the panel guide as the guide, drill a 1/8" hole in the bottom track.
Fasten the panel guide with a #6-32 x 5/16" flathead screw.
Sterling
Measure
here.
Panel Guide
Midway Between
Wall Jambs
9
#6-32 x 5/16"
Flathead Screw
1034038-2-B