Additional Safety Rules - Makita BO5020 Manuel D'instructions

ENGLISH
1 Abrasive disc
2 Dust bag
3 Dust nozzle
4 Push button
5 Hook
6 Groove
7 Front fixing cardboard
8 Front side of paper dust bag
SPECIFICATIONS
Model
Pad diameter ........................................................................ 123 mm
Abrasive disc diameter ......................................................... 125 mm
Orbits per minute ................................................................. 12,000
Overall length ....................................................................... 288 mm
Net weight ............................................................................ 1.4 kg
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Intended use
The tool is intended for the sanding of large surface
of wood, plastics and metal materials as well as
painted surfaces.
Power supply
The tool should be connected only to a power supply
of the same voltage as indicated on the nameplate,
and can only be operated on single-phase AC supply.
They are double-insulated in accordance with Euro-
pean Standard and can, therefore, also be used from
sockets without earth wire.
Safety hints
For your own safety, please refer to the enclosed
Safety instructions.

ADDITIONAL SAFETY RULES

1. Hold the tool firmly.
2. Do not leave the tool running. Operate the
tool only when hand-held.
3. This tool has not been waterproofed, so do
not use water on the workpiece surface.
4. Ventilate your work area adequately when
you perform sanding operations.
5. Some material contains chemicals which may
be toxic. Take caution to prevent working
dust inhalation and skin contact. Follow
material supplier safety data.
6. Always use the correct dust mask/respirator
for the material and application you are work-
ing with.
Explanation of general view
9 Claws
10 Upper part
11 Notch
12 Guide
13 Screwdriver
14 Front grip
15 Hole in front grip
16 Notches
7.
SAVE THESE INSTRUCTIONS.
OPERATING INSTRUCTIONS
Installing or removing abrasive disc (Fig. 1)
Important:
Always be sure that the tool is switched off and
unplugged before installing or removing the abrasive
disc.
To install the abrasive disc, first remove all dirt or for-
eign matter from the pad. Then attach the abrasive
disc to the pad, using the hook-and-loop system of
the abrasive disc and the pad. Be careful to align the
holes in the abrasive disc with those in the pad.
CAUTION:
Always use hook-and-loop system abrasive discs.
Never use pressure-sensitive abrasive discs.
ENB042-4
Installing dust bag (Fig. 2)
Install the dust bag on the tool so that the arrow with
"UP" indicated on the dust nozzle points upward.
Emptying dust bag
When the dust bag is about half full, switch off and
unplug the tool. Hold the tool as shown in Fig. 3 and
remove the dust bag from the dust nozzle while
pressing the push button as shown in Fig. 4.
(Fig. 3 & 4)
After emptying the dust bag, insert the hook on the
dust nozzle into the rectangular hole on one side of
the dust bag frame and push up the dust bag frame
until it clicks into place on the push button. (Fig. 5)
17 Speed adjusting dial
18 Lock button
19 Switch trigger
20 Sponge pad
21 Felt pad
22 Wool pad
BO5020
Be sure that there are no cracks or breakage
on the pad before use. Cracks or breakage
may cause a personal injury.
BO5021
123 mm
125 mm
4,000 – 12,000
288 mm
1.4 kg
5