Bosch B36CT Série Manuel D'utilisation page 27

Issue
Water output is reduced.
Water is dripping from the water
dispenser.
The water dispenser is not func-
tioning.
Ice cube production is low.
The ice maker is not functioning.
Cause and troubleshooting
Low water pressure.
Check the pressure of the water supply system or the external water filter sys-
▶
tem, e.g. reverse osmosis system.
Connect the appliance only to a water connection with sufficient water pressure.
→ Page 6
The water filter is blocked.
Change the water filter. → Page 19
▶
Air is in the water system.
Keep dispensing water until it contains no more air.
▶
There is no water supply.
Ensure that there is a water supply and that the shut-off valve on the water con-
▶
nection is open.
Contact an installer if necessary.
Kink in the water hose.
Turn off the water supply and straighten the kink in water hose.
▶
If necessary, replace the water hose.
The appliance has only recently been connected.
Wait approximately 4 hours until the first batch of ice cubes is ready.
▶
The freezer compartment has been opened frequently or for an extended period of
time.
Check ice cube production after a few hours.
▶
Low water pressure.
Check the pressure of the water supply system or the external water filter sys-
▶
tem, e.g. reverse osmosis system.
Connect the appliance only to a water connection with sufficient water pressure.
→ Page 6
The water filter is blocked.
Change the water filter. → Page 19
▶
Food or objects are blocking the fill level sensor for the ice maker.
Remove all food and objects from the ice storage container.
▶
Fault in the ice maker.
Switch off the appliance. → Page 13
1.
Disconnect the appliance from the power supply.
2.
Unplug the power plug or switch off the circuit breaker in the fuse box.
Reconnect the appliance after 5 minutes.
3.
Switch on the appliance. → Page 13
4.
If the fault persists, call customer service. → Page 29
5.
Ice cube production is switched off.
Switch on ice cube production. → Page 20
▶
There is no water supply.
Ensure that there is a water supply and that the shut-off valve on the water con-
▶
nection is open.
Contact an installer if necessary.
Kink in the water hose.
Turn off the water supply and straighten the kink in water hose.
▶
If necessary, replace the water hose.
Fault in the ice maker.
Switch off the appliance. → Page 13
1.
Disconnect the appliance from the power supply.
2.
Unplug the power plug or switch off the circuit breaker in the fuse box.
Reconnect the appliance after 5 minutes.
3.
Switch on the appliance. → Page 13
4.
If the fault persists, call customer service. → Page 29
5.
Troubleshooting en-us
27