Care And Cleaning; Hob; Hob Frame; Fixing Malfunctions - Siemens EH6 TA1 Série Notice D'utilisation

Press the @ symbol several times until the required
3.
function appears.
Then select the required setting using the + and - symbols.
4.

Care and cleaning

The advice and warnings contained in this section aim to guide
you in cleaning and maintaining the hob, so that it is kept in the
best possible condition

Hob

Cleaning
Clean the hob after each use. This prevents food remains left
on the surface from burning. Wait until the hob is cold enough
before attempting to clean it.
Only use cleaning products specifically designed for glass-
ceramic hobs. Follow the instructions provided on the
packaging.
Do not use:
Abrasive products
■
heavy-duty cleaners, like oven sprays and stain removers
■
Pads that may scratch
■
High-pressure or steam cleaners
■
Glass scraper
Remove dried-on food remains using a glass scraper.

Fixing malfunctions

Malfunctions are commonly due to small details. Before calling
the Technical Assistance Service, you should consider the
following advice and warnings.
Indicator Malfunction
none The electric power supply has been
interrupted.
The appliance has not been correctly
connected according to the connection
diagram.
Electronic system malfunction.
flashes The control panel is damp or an object is
"
resting on it.
Electronic system malfunction.
+ number /
"§
š + number /
¡ + number /
* If the indication persists, call the Technical Assistance Service.
Do not rest hot pans on the control panel.
28
Press the @ symbol again and hold it for more than 4
5.
seconds.
The settings will have been correctly stored.
Quit
To leave the basic settings, turn off the hob at the main switch.
Release the scraper safety catch
1.
Use the blade to clean the hob surface
2.
Do not attempt to clean the hob surface with the base of the
scraper. This could result in scratching.
ã=
Risk of injury!!
The blade is extremely sharp. Risk of cuts. Protect the blade
when not in use. Replace the blade immediately when any
imperfections are found.
Care of the appliance
Apply an additive to protect and preserve the hob. Follow the
advice and warnings provided with the product.

Hob frame

In order to avoid damage to the hob frame, follow the
indications below:
Use only slightly soapy hot water
■
Do not use sharp or abrasive products
■
Do not use a glass scraper
■
Solution
Use other electrical appliances to check whether there has been a
power cut.
Check that the appliance has been connected correctly according to
the connection diagram.
If the above checks do not resolve the malfunction, contact the
Technical Assistance Service.
Dry the control panel area or remove the object.
Turn the hob off from the mains. Wait 30 seconds or so and switch it
back on.*